Great replacement water filter
"Works great and would buy again"
Pentair SW-1A 150539 Llave de filtro para carcasa delgada
Q&As
Pentair SW-1A 150539 Llave de filtro para carcasa delgada
Q&As
Part Number:
150539
Alt Part Number:
SW-1A
La llave para filtro de línea delgada permite la rápida extracción e instalación de carcasas de filtro delgadas de 4.5 pulgadas de diámetro.
Read More
IN STOCK
Descripción
Esta llave está diseñada para ayudar con la extracción e instalación de carcasas Slim Line (4.5" de diámetro) durante los cambios de cartuchos de filtro. También es compatible con la mayoría de las carcasas de filtro de 2.5" debajo del fregadero.
This Item Fits These Select Systems
Customer Reviews
Overall rating: 5.0 / 5 from 2 reviews.
AI Generated Review Summary
Summary topics
Review topics: [].
Review highlights
Reviews
Great replacement water filter
"Works great and would buy again"
Arrived promptly, easy to install
"We recently bought a house with a Viqua system. It took me a while to locate the source of the beeping, but ordering a replacement lamp and installing it was easy."
Q&A
Frequently Asked Questions
Q:
Which filter housings is the Pentair SW-1A 150539 designed to fit?
A:
The product page identifies Slim Line housings and many 2.5-inch under-sink housings. The catalog has no model-specific Fits value, so compare the cap and sump profile.
Q:
Does housing length affect whether this wrench fits?
A:
It is intended for Slim Line housings and many 2.5-inch under-sink filter housings. Housing diameter and cap profile are the critical fit points; a 10-inch and 20-inch housing in the same series can use the same wrench.
Q:
How should I use the wrench without damaging the housing?
A:
Shut off the water, open a downstream faucet, and fully relieve pressure first. Support the housing head, keep the wrench square on the sump, and apply steady force rather than impact.
Q:
Should I tighten the housing with the wrench?
A:
Hand-tighten the sump and follow the housing instructions. A wrench is mainly for loosening a stuck sump; using it as a torque handle can overtighten the housing or distort the O-ring seal.
Q:
Why might the wrench slip even if the housing looks similar?
A:
Similar housings can have different outside diameters, ribs, and cap shapes. The product page describes a housing diameter of about 4.5 inches. Match the housing series and wrench part number rather than cartridge size alone.
Q:
What else should I inspect during a filter change?
A:
Clean the housing groove, inspect the O-ring for cuts or flattening, apply only approved silicone lubricant if needed, reinstall the cartridge correctly, and check for leaks after repressurizing.
