UF22 Sump Slimline Wrench
"Fits perfectly"
Pentair SW-2 150295 Filter Wrench for 10 in and 20 in Standard Housings
This wrench will assist in removing and attaching 10" and 20" standard housings (5" diameter) when changing filter cartridges. The tool is compatible with most standard, whole-house filter housings.
Overall rating: 5.0 / 5 from 4 reviews.
Review topics: [].
"Fits perfectly"
"Great"
"Good, sturdy, usable wrench."
"Great help to change filters"
Q:
Which filter housings is the Pentair SW-2 150295 designed to fit?
A:
Use it with the 10-inch and 20-inch standard housings described on the product page. The catalog has no model-specific Fits value, so verify the sump profile before ordering.
Q:
Does housing length affect whether this wrench fits?
A:
It is intended for 10-inch and 20-inch standard housings. Housing diameter and cap profile are the critical fit points; a 10-inch and 20-inch housing in the same series can use the same wrench.
Q:
How should I use the wrench without damaging the housing?
A:
Shut off the water, open a downstream faucet, and fully relieve pressure first. Support the housing head, keep the wrench square on the sump, and apply steady force rather than impact.
Q:
Should I tighten the housing with the wrench?
A:
Hand-tighten the sump and follow the housing instructions. A wrench is mainly for loosening a stuck sump; using it as a torque handle can overtighten the housing or distort the O-ring seal.
Q:
Why might the wrench slip even if the housing looks similar?
A:
Similar housings can have different outside diameters, ribs, and cap shapes. The Shopify page describes the applicable standard-housing body as approximately 5 inches in diameter. Match the housing series and wrench part number rather than cartridge size alone.
Q:
What else should I inspect during a filter change?
A:
Clean the housing groove, inspect the O-ring for cuts or flattening, apply only approved silicone lubricant if needed, reinstall the cartridge correctly, and check for leaks after repressurizing.